radial distance

Traditional methods of technical efficiency measurement include parametric method and the non-parametric DEA based on radial technology distance function mainly.

传统的技术效率测算方法主要包括参数方法和基于径向技术距离函数的非参数DEA方法。

The distance of skin to radial artery, inside diameter, area, area ratio, pulsate index and flow were of good value on pulse strength.

对确定脉力有价值的指标是皮肤表面到桡动脉的距离、管腔内径、管腔面积、面积的比值、搏动指数和血流量；

A central force is a radial force which depends only on the distance from the origin.

有心力是一种径向力,它的大小只取于离原点的距离.

Radial velocity is bigger on axis top of tunnel at the distance of 3 times of radius to free face.

隧洞开挖的轴向洞顶距离掌子面3倍洞径处会出现一个爆破振速增大的区域。

Influence of inner ring double raceways centre distance of self-aligning roller bearing on radial clearance

调心滚子轴承内圈两滚道中心距对径向游隙的影响自动调心球面滚子轴承

The system's each receiving station only sends the target's exact radial distance to data processing center.

该算法只需要组网雷达系统给数据处理中心提供每个接收机所测得的准确径向距离，然后根据推广卡尔曼滤波技术迭代估算出目标的位置。

This new method can obtain the direction of the target with phase information of two orthogonal interferometers on the observer and the radial distance with the corresponding phase rate of change. Then the target can be located with high speed and precision.

该方法利用观测平台上两个相互正交的相位干涉仪接收目标辐射电磁波的相位获取目标的方向信息，利用对应的相位变化率获取目标的径向距离信息，从而实现对目标的实时高精度定位。

The shear crack would expand along the shear direction and the tensile crack would expand some distance along the radial direction and then expand along the shear direction in this experimental strain-rate.

在实验加载应变率范围内，剪切裂纹在外壁面萌生后会一直沿剪切方向向内壁面扩展，拉伸裂纹在沿径向扩展一段距离后，转而沿剪切方向扩展。

The results indicate that not only segregation phenomenon of primary carbide in the semi-solid structure but also sharp dividing line of the segregation, where the dividing line locates at the distance of about 6 mm from the radial outer face of the annular parts, can be observed.

结果表明，首先在半固态组织中初生碳化物出现偏析现象，且存在明显的偏析分界线，分界线位于距离环形铸件径向外侧面约6mm处。

Determination of the minimum distance of the safe point of approach and attention DCPA Radial distances from CP or CL are too short.

最小安全会遇距离和注意会遇距离的确定从投影中心或投影中线的辐射距离太短。